I can also use mstsc /multimon as a command line to use multiple monitors. To get a list of monitors, I can run mstsc /l to LIST out all my monitors on my machine. Hope this helps and please help to accept as Answer if the response is useful. I can put on selectedmonitors:s:x,y and then use the zero-based numbers to indicate my monitors. Microsoft does not guarantee the accuracy and effectiveness of information. The local computer is often referred to as the 'client'. It is a special network protocol which allows a user to establish a connection between two computers and access the Desktop of a remote host. However, the total resolution across all monitors must be. Please note: Information posted in the given link is hosted by a third party. span monitors:i:1 use multimon:i:1 selectedmonitors:s:0,1 I can put on selectedmonitors:s:x,y and then use the zero-based numbers to indicate my monitors. mstsc.exe is the built-in client software which allows connecting to a computer via Remote Desktop Protocol (RDP). Remote Desktop connection supports screens high resolution that can be split over multiple monitors. TeamViewers multi-monitor support allows users to connect to devices with multiple monitors. Remote Desktop: /span across multiple monitorsģ.If you are looking for method to use 1 of your 2 physical monitors(client side) during remote session, please refer to following blog as this feature is still in request on the Uservoice forum. Change the RDS shortcut to have /span switch after mstsc. 1.The Multiple monitor support feature enables users to utilize all the monitors connected to the client computer for the Remote Desktop connection rather than the monitors of target server.Ģ.But for /scan mode, there are some limitations as stated in below KB: place of main monitor, The set of monitors must form a rectangle as well as total resolutions:
0 Comments
Leave a Reply. |